OFRF nexMESH Subohm Tank
The OFRF nexMesh subohm tank is a first of its kind with conical shaped mesh coil heads. These new heads act as a funnel to condense the vape as it travels up the chamber and the tank design has further condensing action with the top cap so the flavour is as good as it gets for this category of tank. The kit comes with two heads, a kanthal A1 and a stainless steel mesh coil so you can actually use this mesh sub ohm tank in temperature control mode if you desire. The heads have dual layers of cotton for maximum liquid wicking so it will keep up with some serious chain vaping. The top cap is a sliding design with a membrane fill port for simple and mess-free filling. The coil heads are a push fit design so swapping out your coils is simple and less messy than standard screw in type coils.
- Conical shaped nexMesh coil heads
- T.A.S. (twin absorption wicking system)
- Double vapour compression system
- Shock resistant (with straight poly tank installed)
- Bubble glass
- Simple and leak free top fill
Each Tank includes:
- nexMesh Sub ohm tank
- 1 x 0.2Ω kanthal coil head (preinstalled)
- 1 x 0.15Ω SS coil head
- 1 x removable delrin 810 style tip
- 1 x bubble tank
- Spare o-rings
- User manual
Compatible parts (available separately)
OFRF nexMESH Conical Mesh coils
OFRF nexMESH 4ml Poly tank
25mm wide at the base
40mm long (not including 510 thread)
Atomiser heads are disposable consumable parts and as such, are covered by our DOA warranty only. See our Terms & Conditions for more information.
These are sub-ohm heads and you must make sure the battery device you are using is fully capable of safely supporting the required drain rate. We strongly recommend you thoroughly research the topic before embarking on any experiments with sub-ohming. We will not accept any responsibility for any damage caused by sub-ohming activity.
A few e-liquid ingredients are known to react with acrylic and plastic tanks and tubes, please see Polycarbonate Issues for more information.