Kanger KBOX200 device
The Kanger KBOX200 is a compact dual 18650 box mod device with a maximum 200W of power at your fingertips. The device supports temperature control with not only Ni200 coils but there is support for Titanium, stainless steel and Nichrome as well. You'll be able to fire coils all the way down to 0.05Ω in temp mode and the 200W available power means that even the largest coils will come up to temperature quickly. The battery door is held in place securely with magnets so you can swap the batteries out quickly.
Please note: Batteries are not included with this kit and we recommend starting out with a pair or two of brand new 18650 cells and "marry" each pair together so they drain and charge at the same rate throughout their life. Any differences in the cell capacity will effect the device run time dramatically. We recommend a pair of the AW IMR18650 3000mAh.
- 200 Watts
- Temperature control
- Variable temperature with Ni200, Ti, Stainless, or Nichrome coils
- Dual 18650 battery bay (batteries not included)
- Self-adjusting spring loaded 510 atomiser connection
- Resistance range 0.05Ω and above
- Charge via micro USB
- Large easy to read OLED display
- Upgradeable firmware via USB port
- Reverse polarity, output short, low resistance, low battery, voltage and overheat protection
- Kanger KBOX200
- User Manual
Plug the USB cable into the port on the side of the device, and connect to an approved USB wall adapter, or other USB power source. You'll need to purchase two new 18650 cells for this device and keep them in a pair at all times during use and while charging (if you decide to use an external Li-Ion charger, available separately.)
IMPORTANT: To benefit from the temperature limit settings a coil made from suitable temperature controllable resistance wire is required. Standard Kanthal A1 will not allow temperature control.
Batteries NOT included.
60 day warranty.