Aspire Loomix Replacement pods - 2pk

Aspire Loomix Replacement refillable pods - 2pk (Fixed coil installed)

Pack of two pods for the Aspire Loomix Vape Kit. Each pod features an integrated coil in your choice of resistance, offering flexibility for different vaping preferences, from a tighter MTL (mouth-to-lung) inhale to a looser RDL (restricted direct lung) draw. Their advanced nichrome mesh design ensures an immensely flavourful vape, and when the coil reaches the end of its life, you simply swap out the entire pod - no coil changes required.

Loomix pods are all designed for use with 50/50 e-liquids, making them a practical choice for everyday vaping.

Available in two sizes in the following resistances:

• 1.0Ω (11-13W) Tight Mouth to lung (MTL) for pronounced flavour and modest vapour production.
• 0.8Ω (13-15W) Mouth to lung (MTL) balanced flavour and vapour production - this is the option that comes as standard in the Loomix kit.
• 0.6Ω (16-19W) Mouth to lung (RDL/MTL) balanced flavour and vapour production with a more open airflow and slightly warmer vapour.
• 0.4Ω (21-27W) Restricted Direct Lung (RDL) most wide open airflow for enhanced vapour production.

Refilling the Aspire Loomix pods

1. Remove mouthpiece. Snap off the black cap by pushing sideways and up with your thumb (brace with your index finger on the other side of the pod).
2. Locate the fill port. Underneath the cap, you'll see two holes, an open central hole (for airflow) and a membrane-covered fill port).
3. Fill with e-liquid. Push your bottle nozzle down into the fill port located to the side of the central air hole and squeeze the bottle gently to fill. Never put e-liquid into the central hole. 
4. Do not overfill. Fill to about 90% capacity leaving a small air bubble at the top of the pod to prevent leaks caused by pressure buildup. 
5. Replace the mouthpiece. Snap the mouthpiece back onto the top of the pod. Ensure it clicks into place securely.
6. Prime the coil. When using a new pod, wait 5-10 minutes before vaping to allow the e-liquid to fully saturate the cotton wick, preventing a burnt taste.

If the pod is gurgly when you vape, it indicates that excess liquid was pushed into the coil during refilling. Simply remove the pod from the device, hold it in a tissue whilst you blow sharply through the mouthpiece to deposit excess liquid into the tissue. Wipe the pod and pop it back into the device.

Also see our Vape consumables compatibility chart.

Important:
A few e-liquid ingredients are known to react with acrylic and plastic tanks and tubes, see Polycarbonate Issues for more information.