Taifun Boreas Drip Tip Base section

Taifun^® Boreas Drip Tip Base section

Build your own Boreas Drip tip set with this 510 base and a selection of Boreas Chopsticks or Boreas P-Line Chopsticks.

The design of the Taifun Boreas eliminates the flange at the base of the shank to allow adjustable depth/height of this drip tip series. Depending on the atomiser, the base of the Boreas can reach right to the bottom of the 510 opening, thus creating a seamless connection to the chimney. This eliminates gaps where condensate or liquid can collect, thus actively improving the vape experience. This also results in a variable visible height of the drip tip above the top of your atomiser.

Important safety warning
If you're using an atomiser or tank which has a top coil/deck or a dripper without a 510 drip tip stop, be aware that the Boreas tip can fall through due to its flange-less design. Pay close attention attention to this, as this drip tip can potentially cause a short circuit if the tip were to fall deep enough into the deck to make contact with the coil and/or the coil posts. It is therefore not recommended to use the Boreas tip on the Taifun BTD or Taifun GX in particular, but this warning goes for any other atomiser without a drip tip stop.

Dimensions
Inner diameter/Bore: 3.5 mm

NOTE: A Boreas Chopstick is required to use this part. It is highly recommend that you fully clean out this product before the first time you use it. While the factory does a good job removing machining residues, there is still the potential for trace elements to remain, and it is best recommended that you do an additional cleaning to meet your standard of cleanliness.